Wing Set DUOTONE Aero Carve 2.0 D/Lab

The sharpest front fenders around !

To reduce drag and weight as much as possible, they decided to merge the front wing with the front half of the fuselage. This eliminates any compromise in the design of the front wing and its adaptation to the fuselage support. It also eliminates the three bolts needed to attach the SLS front wings to the fuselages, further reducing drag and weight.

The Carve 2.0 D/LAB, like their SLS variant, are very different from the previous range. Lighter underfoot, they are also more flexible in terms of pitch management, allowing you to switch from heel to toe in a much more natural way to link turns. Thanks to a thinner profile towards the wingtips and a higher aspect ratio, Carve 2.0 D/LAB boasts greater top speed, glide and pumpability than its predecessor.

The Carve 2.0 D/LAB range is based on the Carve 2.0 SLS range, but with a few minor modifications. The aspect ratio is slightly lower and the profile a little thinner and faster than on the SLS range, to enable these kites to be pushed at higher speeds, whether for riding down fast waves, launching the most technical freestyle tricks or even using them for Wing Foil or Kite Foil racing.

The range also comes in two smaller sizes, the 650 and 500, but does not include the larger 1430 found in the SLS range.

Finally, the D/LAB range includes two carbon rear wing options, 37 cm and 43 cm, corresponding respectively to the lengths of our 60 cm and 66 cm AL 3BS fuselages, depending on whether you're looking for a freer, more playful character or greater control at higher speeds.

Carve 2.0 D/LAB are the ideal choice for experienced riders who want performance above all else.

STABILIZER P

Our latest range of stabilizers, specially designed to complement our Carve 2.0 and Glide ranges.

The P series is synonymous with performance! We've increased the aspect ratio of the stabilizers so that they produce more lift while being smaller in area. This has enabled us to reduce drag and increase handling without losing the high-speed control for which our foils are renowned.

P stabilizers are available in four sizes, 165 / 180 / 200 / 220. Each one has been fine-tuned to fit our new front wings perfectly. These new stabilizers are almost completely flat, and have lost the fins found on our other range: the C Stabilizers. These changes have enabled us to free up the feel in the corners, spicing up the behavior of our new front wings.

Our new thin shims allow you to modify the angle of attack of your stabilizer in increments of +/- 0.3 degrees, so you can take full advantage of daylight conditions or adapt your foil to your style.

Highly responsive for intuitive surfing and explosive freestyle pop

Maximum weight reduction for improved jumping and surfing performance

Fast, minimum drag individually optimized for each size

Improved pumping and glide over the previous Carve range

Optimized profiles and curves for every wing size

Our smallest and most radical kite. The Aero Carve 2.0 D/LAB 500 is designed for kids, lightweight champions or expert riders who want to tackle big waves or foil at stratospheric speeds. It has been optimized to maintain a good level of control at full speed with the 43 cm rear wing, or to be ultra-maneuverable with the 37 cm rear fender. Ideally combined with the P 165 stabilizer and the +0.3 degrees shim.

The second-smallest wing in our range, designed for light or experienced riders looking for extra speed, whether they're tackling big waves, freestyling in a wing or challenging their friends in a race. It is equipped with a 37 cm rear wing for maximum maneuverability, or a 43 cm rear fender for more control at high speed. Ideally paired with the P 165 stabilizer and +0.3 degree shim.

The Aero Carve 2.0 D/LAB 850 has it all: it turns and responds instantly in waves, reaches impressive speeds in Wing and Kite, has incredible pop for Freestyle, low drag and enough glide to get through the wind. This is the kite to have in your quiver !

The largest wing in our D/Lab family. Advanced riders will choose this kite for waveriding in small to medium waves, and freestylers will love it in light to moderate wind conditions. Best suited to medium-to-heavy riders or light conditions, the 1100 D/Lab is a versatile kite, slippery for its size and easy to use. It can also be used for Prone, where its turning ability is matched only by the smallest Carve 2.0s.